Configuring A Hierarchical Assured Rate; Changing The Assured Rate To An Hrr Weight - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide

Configuring a Hierarchical Assured Rate

To specify that the HAR is used for scheduler nodes (HAR is not used for queues or
ports):
1.
2.

Changing the Assured Rate to an HRR Weight

To change an assured rate to an HRR weight:
1.
2.
Related Topics
56
Configuring a Hierarchical Assured Rate
host1(config-scheduler-profile)#assured-rate 50000 - 31000
For a static assured rate, specify the bits per second value in the range
25000–1000000000 bps (25 Kbps to 1 Gbps); the default is none (no assured
rate).
Use the operator and operandValue variables to configure an assured rate with
an expression.
Create a scheduler profile.
host1(config)#scheduler-profile har
host1(config-scheduler-profile)#
Specify the hierarchical keyword with the assured-rate command in the
scheduler profile.
host1(config-scheduler-profile)#assured-rate hierarchical
Create a scheduler profile.
host1(config)#scheduler-profile static
host1(config-scheduler-profile)#
Delete the configured assured rate.
host1(config-scheduler-profile)#no assured-rate
The assured rate in the scheduler profile reverts to using the HRR weight
specification.
Static and Hierarchical Assured Rate Overview on page 54
Configuring a Scheduler Profile for a Scheduler Node or Queue on page 48
Configuring the HRR Weight for a Scheduler Node or Queue on page 57
For more information about specifying an expression that you can reference
within a scheduler profile, see Using Expressions for Bandwidth and Burst Values
in a Scheduler Profile on page 48
assured-rate
scheduler-profile