Monitoring Shared Shapers - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

Related Topics

Monitoring Shared Shapers

Display information about the configured shared shapers.
Purpose
The best-effort queue is listed as the first resource for shared shapers that are queue
controlled. The best-effort scheduler node is listed as the first resource for shared
shapers that are node controlled.
To display information about configured shared shapers for a specific interface:
Action
host1#show qos shared-shaper interface atm 11/0
----------------- --------------------------- ------- ------- -----------
atm-vc ATM11/0.10 A atm-vc node
atm-vc ATM11/0.11 A atm-vc node
A atm-vc queue EF voice
To display information about configured shared shapers for a specific L2TP session:
host1#show qos shared-shaper l2tp-session session1
To display information about the interface at the root of the scheduler hierarchy
located on the tunnel-service interface or at the same hierarchy for LNS GRE tunnel
traffic:
host1#show qos shared-shaper tunnel-server 6/0
To display information about the shared shapers for an interface set:
host1#show qos shared-shaper qos-interface-set gigEbusiness
To display information about the shared shapers for an interface superset:
Configuring a Scheduler Hierarchy on page 47
Configuring Simple Shared Shaping on page 81
Configuring Compound Shared Shaping on page 100
show scheduler-profile
interface
atm-vc queue best-effort
atm-vc node
A atm-vc queue EF voice
atm-vc node
A atm-vc queue AF video
atm-vc queue best-effort
atm-vc node
atm-vc node
A atm-vc queue AF video
Total shared shapers:
Total constituents:
Total shared shaper failovers: 0
Compound shared shapers are not supported
Chapter 31: Monitoring QoS on E Series Routers
shared
shaping shaping
resource rate
500000
EF
AF
500000
EF
100000
AF
2
12
Monitoring Shared Shapers
rate other
rate 500000
100000
200000
rate 500000
200000
329