Chapter 23 Configuring Interface Sets For Qos; Interface Sets For Qos Overview; Interface Set Terms - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

Chapter 23
Configuring Interface Sets for QoS

Interface Sets for QoS Overview

Interface Set Terms

This chapter describes how to configure a set of logical interfaces with the same
scheduling and queuing properties using interface sets.
QoS topics are discussed in the following sections:
Interface Sets for QoS Overview on page 207
Architecture of Interface Sets for QoS on page 208
Configuring Interface Sets for Scheduling and Queuing on page 211
Configuring Interface Supersets for QoS on page 212
Configuring Interface Sets for QoS on page 213
Adding Member Interfaces to an Interface Set on page 214
Creating a QoS Parameter on an Interface Superset or Interface Set on page 216
Attaching a QoS Profile to an Interface Superset or an Interface Set on page 218
Deleting an Interface Superset or an Interface Set on page 219
Example: Configuring Interface Sets for 802.3ad Link Aggregation
Groups on page 220
This topic describes how to use interface sets to configure a set of logical interfaces
with the same scheduling and queuing properties.
Interface sets are supported for VLANs, ATM VCs, and IP.
You can use interface sets for various scenarios in a broadband access network. For
example, you can use an interface set to configure a local loop with a small number
of subscribers. Interface sets are also useful for grouping a large number of subscribers
into a particular service class or for defining traffic engineering aggregates for DSLAMs.
Table 21 on page 208 lists the terminology used for interface sets
Interface Sets for QoS Overview
207