Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual page 317

c. Configure an instance-interface type.
Create the parameter instance and configure the shaping mode.
3.
When you create the parameter instance and configure the shaping mode, the
value of frame shaping mode is 0; the value for cell shaping mode is 1.
host1(config)#interface gigabitEthernet 6/0/2
host1(config-if)#encapsulation vlan
host1(config-if)#interface gigabitEthernet 6/0/2.1
host1(config-if)#vlan id 1
host1(config-if)#qos-parameter cell-mode 1
host1(config-if)#ip address 6.10.10.10 255.255.255.255
host1(config-if)#exit
host1(config)#interface gigabitEthernet 6/0/2
host1(config-if)#svlan 1 qos-parameter cell-mode 1
host1(config-if)#exit
host1(config)#interface gigabitEthernet 6/0/2
host1(config-if)#qos-parameter cell-mode 1
Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell Mode
Related Topics
on page 284
Example: QoS Parameter Configuration for QoS Cell Mode and Byte Adjustment
for Cell Shaping on page 286
For more information about configuring scheduler rates for QoS parameters, see
Scheduler Profiles and Parameter Expressions for QoS Administrators on page 235
For more information about the QoS downstream rate application, see QoS
Downstream Rate Application Overview on page 301
controlled-interface-type
instance-interface-type
interface gigabitEthernet
ip address
qos-parameter
qos-parameter-define
scheduler-profile
svlan qos-parameter
traffic-class
vlan id
Chapter 28: Configuring the Shaping Mode for Ethernet with QoS Parameters
host1(config-qos-parameter-define)#instance-interface-type vlan
Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell Mode
285