Figure 62: Hierarchical Parameters Scheduler Hierarchy; Procedure For Qos Administrators - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide

Figure 62: Hierarchical Parameters Scheduler Hierarchy

Procedure for QoS Administrators

This section describes the procedures to configure the scheduler hierarchy shown in
Figure 62 on page 264 by using QoS parameters.
The QoS administrator configures the parameter definition for the maximum
Configuring the
subscriber bandwidth.
Parameter Definition
To configure a parameter definition for the maximum subscriber bandwidth:
1.
2.
3.
4.
5.
The QoS administrator can then reference the parameter definition within a scheduler
Configuring the
profile, which defines the shaping rates for the parameter.
Scheduler Profiles
1.
264
Example: QoS Parameter Configuration for Hierarchical Parameters
Configure the parameter definition named max-sub-bw.
Enable the parameter to control S-VLANs.
Enable the parameter to control VLANs.
Enable the parameter to have instances created on VLAN subinterfaces.
Specify that the QoS client can create the parameter instance for VLANs, which
represent subscribers.
host1(config)#qos-parameter-define max-sub-bw hierarchical
host1(config-qos-parameter-define)#controlled-interface-type svlan
host1(config-qos-parameter-define)#controlled-interface-type vlan
host1(config-qos-parameter-define)#instance-interface-type vlan
host1(config-qos-parameter-define)#subscriber-interface-type vlan
host1(config-qos-parameter-define)#exit
Configure a scheduler profile to shape the throughput the explicit QoS parameters
for VLANs.
a. Configure the scheduler profile named sp-shape-cvlan.