Example: Qos Parameter Configuration For Qos Downstream Rate - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

Related Topics

Example: QoS Parameter Configuration for QoS Downstream Rate

This example illustrates how to use parameters to control the downstream rate
obtained from ANCP.
In this example, the subscribers on the 0.1 access loop are configured on VLAN1.
They subscribe to voice, video, and data traffic with a bandwidth of 10 Mbps.
Subscribers on the 1.1 access loop are configured on VLAN2, and subscribe to 1 Mbps
of data traffic.
Table 33 on page 306 lists the shaping mode and shaping rate information received
by the QoS downstream rate application upon access loop synchronization. The
parameter instances are created with these values.
Chapter 30: Configuring the Downstream Rate Using QoS Parameters
host1(config-if)#ip address 6.10.10.10 255.255.255.255
Example: QoS Parameter Configuration for QoS Downstream Rate on page 305
For information about downstream rate and RADIUS, see JUNOSe Broadband
Access Configuration Guide
For more information about configuring ANCP (L2C) parameters, see JUNOSe IP
Services Configuration Guide
aaa qos downstream-rate
controlled-interface-type
encapsulation vlan
instance-interface-type
ip address
node
qos-parameter
qos-adaptive-mode
qos-parameter-define
qos-profile
queue
shared-shaping-rate
subscriber-interface-type
traffic-class
vlan id
Example: QoS Parameter Configuration for QoS Downstream Rate
305