Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual page 165

host1(config-qos-profile)#atm group groupA scheduler-profile scheduler1
When you configure a group node, you can also reference a default or named
traffic-class group, a scheduler profile, or a statistics profile.
If you do not specify a traffic-class group, the group node defaults to the default
group. Each traffic class can belong to only one traffic-class group (either the
default group or a named group).
The router supports up to four traffic-class groups above a given port.
(Optional) Configure a scheduler node for interfaces.
3.
host1(config-qos-profile)#atm node scheduler-profile scheduler1 group
When you configure a scheduler node, you can also reference a default or named
traffic-class group and a scheduler profile.
The scheduler profile supplies a relative weight and potentially a shaping rate to
be applied at the scheduler node.
NOTE: You cannot associate a scheduler profile with a port-type interface unless you
also specify the strict-priority group.
(Optional) Configure a queue for interfaces in the specified traffic class.
4.
host1(config-qos-profile)#atm queue traffic-class strict-priority scheduler-profile
When you configure a queue, you can include any of the following profiles:
The scheduler profile supplies a relative weight and potentially a shaping
rate to be applied at the queue.
The queue profile supplies threshold information for the queue if the router
defaults are not appropriate.
The drop profile supplies dropping behavior of a set of egress queues.
Each queue traffic class can appear in only one traffic-class group.
Attaching a QoS Profile to an Interface on page 134
Related Topics
Supported Interface Types for QoS Profiles on page 131
Configuring Shadow Nodes on page 152
Monitoring a Scheduler Hierarchy on an Interface with QoS Profiles on page 155
For information about configuring QoS profiles with Service Manager, see JUNOSe
Broadband Access Configuration Guide
group
node
Chapter 16: Configuring and Attaching QoS Profiles to an Interface
statistics-profile statpro-1
strict-priority
scheduler1 queue-profile queue1 drop-profile drop1
Configuring a QoS Profile
133