Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual page 336

JUNOSe 11.1.x Quality of Service Configuration Guide
3.
4.
5.
6.
7.
8.
304
Configuring a Parameter Definition for QoS Downstream Rate
host1(config)#qos-parameter-define downstreamVLAN application
qos-downstream-rate
b. Configure controlled-interface types.
host1(config-qos-parameter-define)#controlled-interface-type vlan
host1(config-qos-parameter-define)#controlled-interface-type ip
c. Configure subscriber-interface types.
host1(config-qos-parameter-define)#subscriber-interface-type vlan
Do one of the following:
For VLANs, configure the shaping mode by creating a parameter definition
with the QoS cell mode application. Ensure that you specify a
subscriber-interface type.
See "Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell
Mode" on page 284.
For ATM VCs, configure the shaping mode by issuing the qos-shaping-mode
command.
See "Configuring the QoS Shaping Mode for ATM Interfaces" on page 174.
Enable QoS adaptive mode for the system by issuing the qos-adaptive-mode
command in L2C Configuration mode.
host1(config)#l2c
host1(config-l2c)#qos-adaptive-mode
Enable the QoS downstream rate application to use downstream rates obtained
from the Actual-Data-Rate-Downstream [26-130] DSL Forum VSA.
host1(config)#aaa qos downstream-rate
Configure the scheduler profile for the shaping rate.
host1(config)#scheduler-profile vlan1
host1(config-scheduler-profile)#shared-shaping-rate downstreamVLAN * 5 auto
Configure the QoS profile for the shaping rate.
host1(config)#qos-profile vlan1
host1(config-qos-profile)#vlan node scheduler-profile vlan1
Attach the QoS profile to a logical Ethernet interface.
ANCP or AAA dynamically creates the parameter instances for the QoS
downstream rate application, and if applicable, the QoS cell mode application;
therefore, you do not need to specify them.
host1(config)#interface gigabitEthernet 6/0/2
host1(config-if)#encapsulation vlan
host1(config-if)#interface gigabitEthernet 6/0/2.1
host1(config-if)#vlan id 1
host1(config-if)#qos-profile vlan1