Post-Installation Tasks; Subcontainer Searches - Novell NETWARE 6-DOCUMENTATION Manual

Post-Installation Tasks

Subcontainer Searches

22
Novell iFolder Administration Guide
9
(Conditional) If you have a secondary LDAP server, click Secondary
LDAP Settings.
10
Enter the settings for the secondary LDAP server.
Fill in this information only if you have two LDAP directories that
contain usernames that need iFolder accounts. For example, suppose you
have one LDAP directory that contains all your employee usernames and
another LDAP directory that contains all your vendor usernames and you
want the users from both directories to have iFolder accounts. You would
enter the information for a secondary LDAP server.
HINT:
You will fill in the same information for the secondary LDAP server as you
did for your primary LDAP server. To review the primary LDAP server instructions,
see Step 8 on page
11
Finish the NetWare 6 installation and then reboot your server.
12
(Conditional) If you have a DNS name configured for your iFolder server,
verify that the DNS name and its corresponding IP address are in the
SYS:ETC\HOSTS file of your iFolder server.
If you chose to do subcontainer searches, port 389, or if you want LDAP over
SSL, continue with the next section,
IMPORTANT:
These post-installation tasks are not optional. If you disreguard
them, iFolder will not function properly.
If your iFolder selections do not require post-installation tasks, see
"Using Novell iFolder," on page 37
Complete the appropriate post-installation tasks.
To allow iFolder to do a subcontainer search, you must do one of the
following:
Assign the CN property to the Public object
Create an LDAP proxy user
21.
Post-Installation
to learn more about Novell iFolder.
Tasks.
Chapter 6,