Novell NETWARE 6-DOCUMENTATION Manual page 216

9
Check any of the following options that you want NetWare Accelerated
Upgrade to automatically perform during the upgrade, and then click the
right-arrow:
Reboot the target server after the upgrade is completed.
Even if you checked this option, there might be an instance where
you might need to manually reboot the target server once the file
copy is complete.
Update the existing drivers on the target server to NetWare 6 LAN
and disk drivers.
Because NetWare Accelerated Upgrade has renamed the
STARTUP.NCF file to STARTUP.AUP, during auto-detection,
NetWare Accelerated Upgrade will restore the original
STARTUP.NCF and then loads the appropriate .HAM and .CDM
drivers that NetWare 6 supports.
If device drivers are not found for a device currently loaded in the
former STARTUP.NCF or AUTOEXEC.NCF files, the LOAD line
will be deleted or copied to the new file and then commented out.
WARNING:
compatible with NetWare 6, they cannot be replaced during the hardware
auto-detection process and your server cannot be upgraded. To avoid this,
unload any drivers that are not compatible with NetWare 6 before you
complete the upgrade. NetWare Accelerated Upgrade automatically detects
unsupported drivers and will warn you about proceeding.
Remove any unsupported DOS utilities existing on the target server
(NetWare 4 servers only).
10
Review the list of products that NetWare Accelerated Upgrade is going to
install and click the right-arrow.
Once you click the right-arrow, you might need to wait a few minutes
before the Progress Screen appears.
11
Monitor the Progress Screen and click Close when the NetWare 6
Operating System files have been copied to the target server.
Your target server has now been upgraded to a NetWare 6 server. NetWare
Accelerated Upgrade does not install additional network products during
the upgrade. To install additional network products, see
Additional Networking Products" on page
Continue with "Complete Post-Upgrade Tasks."
If the target server contains any disk drivers that are not
Using NetWare Accelerated Upgrade
"Installing
20.
19