Remove Nds From The Source Server - Novell NETWARE 6-DOCUMENTATION Manual

Remove NDS from the Source Server

58
NetWare Migration Wizard 6 Aministration Guide
If the message appears saying that NDS has already been removed, bring
the destination server down and continue with the next section,
NDS from the Source
If NDS was not successfully removed, exit NWCONFIG and enter
NWCONFIG -DSREMOVE at the destination server console.Then follow
this procedure again, beginning with
Once NDS has been removed from the destination server, remove NDS from
the source server.
1
Restart the source server by entering Server at the DOS command
prompt.
2
Enter LOAD INSTALL -DSREMOVE.
This command will instruct INSTALL or NWCONFIG to ignore any
warnings or errors during the removal of NDS.
If your source server is running NetWare 4, enter LOAD INSTALL -
DSREMOVE.
If your source server is running NetWare 5 or later, enter NWCONFIG -
DSREMOVE.
3
Select Directory Options > Remove Directory Services from This Server.
4
Press Enter to skip past any warning screens.
5
Select Yes to remove NDS.
6
Press Enter to skip the error message warning you that NDS is locked.
Ignore, but keep track of, any additional NDS error messages that appear.
7
When the INSTALL or NWCONFIG menu appears again, select Remove
Directory Services again.
If a message indicates that NDS is already removed, continue with the next
section, "Restore NDS to the Source
If NDS was not properly removed, contact Novell Technical Support at 1-800-
858-4000.
Server."
Step 2.
Server."
"Remove