Improving The Remote Management Performance; On The Management Console; On The Managed Device - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual

8 In the Time Interval between Retries option, specify the time period between two retry
attempts. By default, it is 2 minutes.
9 Click OK.
The default values for the Number of Retries and the Time Interval between Retries options are
configured at the zone level. You can override these values at the device level.
3.8 Improving the Remote Management
Performance
The Remote Management performance during a remote session over a slow link or a fast link varies
depending on the network traffic. For a better response time, try one or more of the following:
Section 3.8.1, "On the Management Console," on page 62
Section 3.8.2, "On the Managed Device," on page 62

3.8.1 On the Management Console

In the ZENworks Remote Management Connection window at the console, click Options and set the
following values:
To maximize the Remote Management performance over slow link:
Select the Use 8-bit color option.
Set the Custom compression level to level 6.
Select the Block Mouse Move Events option.
Enable the Suppress Wallpaper option in the Remote Management Settings.

3.8.2 On the Managed Device

The speed of the Remote Management session depends upon the processing power of the
managed device. We recommend that you use Pentium* III, 700 MHz (or later) with 256 MB
RAM or higher.
Do not set a wallpaper pattern.
62 ZENworks 10 Configuration Management Remote Management Reference