Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual page 41

Field Details
Enable Logging Logs session and debug information in the
vncviewer.txt
ZENworks Control Center (ZCC) through Internet Explorer and in the mozilla
installed directory if you launch ZCC through Mozilla* FireFox*.
Route Through Enables the remote management operation of the managed device to be routed
Proxy through a remote management proxy. If the managed device is on a private
network or is on the other side of a firewall or router that is using NAT (Network
Address Translation), the remote management operation of the device can be
routed through a remote management proxy. This option is currently supported
only on Windows.
Fill in the following fields:
Proxy: Specify the DNS name or the IP address of the remote management
proxy. By default, the proxy configured in the
the remote operation on the device is populated in this field. You can specify a
different proxy.
Proxy Port: Specify the port number on which the remote management proxy is
listening. By default, the port is 5750.
NOTE: The Remote Management Audit displays the IP Address of the device
that is running the remote management proxy and not the IP address of the
management console.
Use the Following If an internal certificate authority (CA) is deployed, the following options are not
Key Pair for displayed. If an external CA is deployed, fill in the following fields:
Identification
Private Key: Click Browse to browse to and select the private key of the remote
operator.
Certificate: Click Browse to browse to and select the certificate corresponding
to the private key. This certificate must be chained to the certificate authority
configured for the zone.
The supported formats for the key and the certificate are DER, PEM, and PFX.
If the PFX format is used, both the key and the certificate must be available in
the same file. You should provide this file as an input for both the key and the
certificate.
Enable Cache Path: Enables the primary key and the certificate paths to be
cached on the management console.
This option is currently supported only on Windows.
6 Click OK to launch the selected remote operation.
Starting a Remote Management Operation in Standalone Mode
Before starting the remote management operation in standalone mode, install the Remote
Management viewer. For information on installing the viewer, see
Remote Management Viewer," on page
To start the Remote Management Operation in standalone mode:
1 Double-click the
nzrViewer.exe
novell-zenworks-
file. The file is saved by default on the desktop if you launch
33.
file to launch the ZENworks Remote Management Client.
Proxy Settings panel to perform
Section 2.6, "Installing the
Setting Up Remote Management 41