Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual page 42

2 In the ZENworks Remote Management Connection window that displays, specify the DNS
name or the IP address of the managed device and the port number in the format IP
address~~Port. For example 10.0.0.0~~1000.
3 Specify the DNS name or the IP address of the remote management proxy and the port number
in one of the following formats:
IP address~~Port. For example 10.0.0.0~~5750.
IP address~Port. For example 10.0.0.0~50.
4 Click Connect.
On successful authentication, the remote session starts. By default, a Remote Control session is
launched.
Starting a Remote Management Operation by Using Command Line Options
Before you launch a Remote Management operation from the command line, install the Remote
Management viewer. For information on installing the viewer, see
Remote Management Viewer," on page
To start the Remote Management operation by using the command line options:
1 At the command prompt, change to the directory where the viewer is installed. The viewer is by
default installed to the
Management\bin
2 Execute the following command:
nzrViewer [/options <parameters if any>][IP address of the managed device]
[~~port]
The default port for the managed device is 5950.
For information on the available command line options, see
Options for Launching a Remote Operation," on page
3 Click Connect.
On successful authentication, the remote session starts. If you have not specified the type of
remote operation in the command line, a Remote Control session is launched by default.
However, starting a Remote Management operation by using the command line options has the
following limitations:
If you do not want to specify the
nzrViewer
Management Console does not have SSL certificate option in the security settings of the
Remote Management policy is enabled. However, this is not recommended because the
security of the device is reduced.
If the managed device is a part of the Management Zone, ensure that the certificate presented
by the viewer is valid, signed, and chained to the CA, or the SSL authentication fails.
42 ZENworks 10 Configuration Management Remote Management Reference
33.
<User_Application_Data_Folder>\Novell\ZENworks\Remote
directory.
key
command for SSL authentication, ensure that the Allow connection when Remote
Section 2.6, "Installing the
Section 2.9.1, "Command Line
44.
, , and command line options in the
cert CAcert