4 In the Listening Remote Operators list, select the remote operator you want to open the remote
session with.
or
If the remote operator is not listed, provide the operator's connection information in the
Request Connection fields.
5 In the Operation field, select the type of operation (Remote Control, Remote View, Remote
Diagnostics, File Transfer, or Remote Execute) you want to open.
For information about each operation, see
Operations," on page
6 Click Request to launch the session.
If you want to allow connections to be made from a public network into a private network, deploy
the DNS Application Level Gateway (DNS_ALG). For more information on DNS_ALG, refer to
RFC 2694
2.9 Options for Launching a Remote
Management Operation
When you launch a remote management operation from the command line, you can specify options
to control the behavior of the remote session. For example, specifying the
launches a Remote Control operation on the device and specifying the
toolbar of the viewing window.
Remote Management uses certain options internally when you launch a remote management
operation on a device. For example, the
is ZENworks Rights Authentication. You must not specify these internal options when you use the
command line to launch a remote management operation on a device. For more information on the
options that are internally used, see
Operation," on page
Review the following sections for more information on the remote management options:
Section 2.9.1, "Command Line Options for Launching a Remote Operation," on page 44
Section 2.9.2, "Internal Options for Launching a Remote Operation," on page 47
2.9.1 Command Line Options for Launching a Remote
Operation
Use the following command line options to control a remote operation:
Command Line Options for Launching a Remote Operation
Table 2-1
Command Line Option Parameter
listen
restricted
viewonly
44
ZENworks 10 Configuration Management Remote Management Reference
12.
(http://www.ietf.org/rfc/rfc2694).
47.
port
Section 1.2, "Understanding Remote Management
option specifies that the authentication scheme
zenrights
Section 2.9.2, "Internal Options for Launching a Remote
Description
Enables the listener to listen to the remote session requests on
the port specified. By default, the port is 5550.
Hides the toolbar and system menu.
Launches a Remote View operation on the managed device.
option
remotecontrol
option hides the
notoolbar