Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual page 29

Intruder Detection
Field
Enable Intruder Detection
Suspend Accepting
Connections After [ ]
Successive Invalid Attempts
Automatically Start Accepting
Connections After [ ] Minutes
Session Security
Field
Enable Session Encryption
Allow Connection When
Remote Management Console
Does Not Have SSL Certificate
Allow up to [ ] levels in Viewer
certificate chain
Abnormal Termination
Field
Lock Device
Details
Select this option to enable the detection of invalid or
unauthorized attempts to launch a remote session on the
managed device. Selecting this option enables the subsequent
options in the Intruder Detection section.
Specify the maximum number of consecutive invalid attempts a
remote operator can make before the Remote Management
service on the managed device is blocked. By default, it is five
attempts.
Specify the time in minutes after which the Remote Management
Agent automatically accepts a connection to the managed device.
To manually unblock the Remote Management service, double-
click the ZENworks Adaptive Agent icon, click Security Settings,
then click Enable Accepting Connections if Currently Blocked Due
to Intruder Detection. By default, it is 10 minutes.
Details
Enables session encryption using SSL encryption (TLSv1
protocol). Selecting this option enables the subsequent options in
the Session Security section.
When a remote session is launched from the ZENworks Control
Center, a certificate is automatically generated for a remote
operator. This certificate is used during authentication. Select this
option to allow connections from a Remote Management console
launched outside ZENworks Control Center that might not have
an SSL certificate.
The Novell rights-based and password-based authentication
schemes are played over an SSL encrypted channel. The
establishment of this channel requires the viewer to present a
certificate. This certificate can be signed by an intermediate or a
root certificate authority, thereby creating a certificate chain.
This property defines the maximum number of levels that are
allowed in the viewer's certificate chain. When the ZENworks
internal certificate authority is employed (it is installed by default),
a two-level viewer certificate chain is automatically created while
launching a remote session from ZENworks Control Center.
Details
Locks the managed device when the remote session is terminated
abnormally.
Setting Up Remote Management 29