Setting Up Remote Management; Configuring The Remote Management Settings; Configuring The Remote Management Settings At The Zone Level; Section 2.1, "Configuring The Remote Management Settings - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual

Setting Up Remote Management

2
The following sections provide information on deploying the Remote Management component of
® ®
Novell ZENworks 10 Configuration Management in a production environment:
Section 2.1, "Configuring the Remote Management Settings," on page 19
Section 2.2, "Enabling the Remote Management Listener," on page 23
Section 2.3, "Creating the Remote Management Policy," on page 23
Section 2.4, "Configuring the Remote Operator Rights," on page 30
Section 2.5, "Configuring the Remote Management Password," on page 31
Section 2.6, "Installing the Remote Management Viewer," on page 33
Section 2.7, "Upgrading the Remote Management Viewer," on page 34
Section 2.8, "Starting Remote Management Operations," on page 34
Section 2.9, "Options for Launching a Remote Management Operation," on page 44
Section 2.10, "Installing a Remote Management Proxy," on page 47
Section 2.11, "Configuring a Remote Management Proxy," on page 49
2.1 Configuring the Remote Management
Settings
The Remote Management settings are rules that determine the behavior or the execution of the
Remote Management service on the managed device. The settings include configuration for the
ports, session settings, and performance settings during the remote session. These settings can be
applied at zone, folder, and device levels.
The following sections provide information on configuring the Remote Management settings at the
different levels:
Section 2.1.1, "Configuring the Remote Management Settings at the Zone Level," on page 19
Section 2.1.2, "Configuring the Remote Management Settings at the Folder Level," on page 22
Section 2.1.3, "Configuring the Remote Management Settings at the Device Level," on page 22
2.1.1 Configuring the Remote Management Settings at the
Zone Level
By default, the Remote Management settings configured at the zone level apply to all the managed
devices.
1 In ZENworks Control Center, click Configuration.
2 In the Management Zone Settings panel, click Device Management, then click Remote
Management.
3 Select Run Remote Management Service on Port and specify the port to enable the Remote
Management service to run on that port.
Setting Up Remote Management
2
19