Write (Group 0) Command (0Ah) - HP 2600fx - Optical Disk Drive Command Reference Manual

Write (Group 0) Command (0AH)

This command writes data starting at the specified logical block address.
The Mode Select Commands (15H or 55H) impact all read, write, format
NOTE
and erase commands.
Table 2-18 Write (Group 0) Command CDB
The 9.1 and 5.2 Gbyte capacity drives cannot Format, Erase, Write, or
NOTE
Write and Verify 650 Mbyte and 1.3-Gbyte optical disks.
The 2.6 Gbyte capacity drives cannot Format, Erase, Write, or Write and
Verify 650 Mbyte optical disks.
If this command is issued with any of these drive/media combinations, a
CHECK CONDITION status will result with the Sense Key/Additional
Sense Code set to Data Protect/Write Protected.
NOTE For Write-Once media, byte 5, bit 6 and bit 7 are reserved.
Chapter 2
Byte 7 6
0
1 Logical Unit Number
(0)
2
3 Starting Logical Block Address (LSByte)
4
5 PBA Ers
Cntl
Write (Group 0) Command (0AH)
5 4 3
Operation Code (0AH)
Starting Logical Block Address
Starting Logical Block Address
Transfer Length
Reserved (0
SCSI-2 Drive Command Set
2 1 0
(MSByte)
Flag Link
2-23