Page of 14

HP Surestore 160ex - Optical Jukebox Manual

Adding 2 drives to the c1150 series jukebox - c1154-90001.
Hide thumbs
Adding 2 Drives to the
C1150 Series Jukebox
This upgrade requires code to be downloaded to the controller PCA and the drives.
BEFORE starting this supgrade, obtain the following:
*
The downloadable code required for this upgrade. FTP this code
from hpgrsg.gr.hp.com (15.38.89.10
Further download instructions are available at that address.
* A PC with a SCSI interface and appropriate cables
* A utility to download the code - DOWNLD2 or HP TOOLSET (Version 1.95ce
or later) from CoComp
Important! Read This First
)
using an "anonymous" login.
HP Part No. C1154-90001
Printed in USA June, 1996
Edition 1 0696

Advertising

   Related Manuals for HP Surestore 160ex - Optical Jukebox

   Summary of Contents for HP Surestore 160ex - Optical Jukebox

  • Page 1

    Adding 2 Drives to the C1150 Series Jukebox Important! Read This First This upgrade requires code to be downloaded to the controller PCA and the drives. BEFORE starting this supgrade, obtain the following: The downloadable code required for this upgrade. FTP this code from hpgrsg.gr.hp.com (15.38.89.10 using an "anonymous"...

  • Page 2

    Hewlett-Packard Company, 1996...

  • Page 3: Esd Precautions, Tools Required

    Adding 2 Drives to the C1150 Series Jukebox Upgraded to equivalent of: Before Upgrade..using this kit (# of drives) C1150F/G/H (2 drives) 1 kit (2 drives) C1160F/G/H (4 drives) a. For a performance upgrade, install 32 magazine slots (C1155F/G/H) ESD Precautions The optical disk jukebox contains very sensitive electrical components.

  • Page 4: Kit Contents

    Kit Contents • 2 - 4X MO drives — # C1113-60x00 • 2 - standard drive brackets — # C1170-60x47 • 2 - cable clamps — # 1400-0611 • 2 - drive SCSI cables — # C1173-60x59 • 2 - drive interface cables — # C1170-60x62 •...

  • Page 5: Before You Begin

    Before You Begin Caution Do NOT switch off power to the jukebox until you are sure the . Switching off the jukebox when the SCSI bus is inactive SCSI bus is active can cause data loss and/or indeterminate bus states. When doing this upgrade, be sure that disk cartridges are not If you need to remove moved from their original slot locations.

  • Page 6

    Installing the 2-Drive Upgrade Caution Put on a grounding strap to work inside the outer shell of this jukebox. 1. Remove the left, right and back panels. Refer to Figures 1 and 2. Figure 1: Right-side panel access a. Remove the T-20 screw that holds the bottom edge of the panel. b.

  • Page 7

    Rear, overall arrows, screws Figure 2: Rear access panel d. Remove the 7 T-20 screws around the outer edge of the panel. e. Remove the single screw underneath the bottom of the panel. f. Rotate the back panel back and lift if off the frame.

  • Page 8

    Installing the 2-Drive Upgrade Note There is 1 drive installed in each drive enclosure. To add 2 drives, you will install drive enclosures where the air baffle plate is currently installed. 1. Remove current drive cables from the interposer PCA. 2.

  • Page 9

    Figure 4: Ensuring drive DIP switches are all OFF 4. Install drives in drive enclosures (1 drive in each enclosure). a. Remove the top cable access plate of each drive enclosure by removing the 2 T-10 screws which hold the plate onto the enclosure. b.

  • Page 10

    c. Insert the single drive into the enclosure and position it near the cables at the rear, and in the upper portion of the enclosure — do not mount the drive at this point — the drive interface cable and clip must be mounted in the next step. d.

  • Page 11

    e. Connect the SCSI and drive power cables to the drive. f. Mount the drive into the enclosure using 4 T-10 screws; 2 on each side. g. Replace each drive enclosure’s top cable access plate by inserting and tightening the T-10 screw on each side of the plate.

  • Page 12

    Figure 9: Cables mounted on the interposer PCA Figure 10: Interposer PCA cable layout 7. Download code to the controller PCA and drives. 8. Run the Wellness Test from the control panel to verify installation. 9. Label the jukebox. Place the product upgrade label that came with the capacity upgrade Use the C1160 label. Do not cover the serial number.

  • Page 13

    Note: The label does NOT cover the original serial number. Example Hewlett-Packard Co. label Upgraded to C1170F S/N 9999999999 Original Made in U.S.A. label Figure 11: Correct label position...

This manual also for:

Surestore 80fx - optical jukebox

Comments to this Manuals

Symbols: 0
Latest comments: