Request Sense Error Codes - HP 2600fx - Optical Disk Drive Command Reference Manual

Request Sense Error Codes

This section identifies each of the error responses for the autochanger
"Request Sense Command (03H)", Table 3-5 on page 3-8.
Table B-1 Request Sense - Sense Key Values — Byte 2, Bits 3 through 0
Sense
Key
0H
1H
2H
3H
4H
5H
6H
Appendix B
Name Abbrev.
No Sense NS
Recovered RE
Error
Not Ready NR
Medium Error ME
Hardware HE
Error
Illegal Request IR
Unit Attention UA
Autochanger Error Codes
Request Sense Error Codes
Description
The command completed
successfully.
The last command was
completed successfully with
some recovery action
performed by the
autochanger/controller.
The autochanger cannot be
accessed.
The command terminated
with an unrecovered error
condition that was caused by
a optical disk defect.
The autochanger/controller
detected a hardware error.
There was an illegal
parameter in the command
descriptor block or in the
additional parameters
supplied for some commands.
The optical disk has been
loaded, the unit has been
reset, or the Mode Select
parameters have been
changed.
B-3