HP 2600fx - Optical Disk Drive Command Reference Manual page 303

Autochanger Error Codes
Additional Sense Data Format for Error Recovery
MvCap A Move Capable bit of 1 indicates the AC is capable of
performing move commands.
LastSCSI A Last bit of 1 indicates the AC has successfully
returned the cartridges to the state they were in before
the failed command was executed.
PosLost A Position Lost bit of 1 indicates the AC cannot
calibrate the mechanism and has lost position of the
picker.
CartIn A Cartridge in Transport bit of 1 indicates a cartridge is
in the picker mechanism.
DInRty A Drive Insert Retry bit of 1 indicates that more than
one attempt was needed to insert the cartridge into the
drive. (For Byte 26, this attempt refers to Retry
algorithm and for Byte 30 it refers to Recovery
algorithm.).
DEjRty A Drive Eject Retry bit of 1 indicates that more than one
attempt was needed to eject the cartridge from the
drive. (For Byte 26, this attempt refers to Retry
algorithm and for Byte 30 it refers to Recovery
algorithm.)
PkrRec A Picker Retracted bit of 1 indicates the picker fingers
were fully retracted after a failure. (For Byte 26, this
attempt refers to Retry algorithm and for Byte 30 it
refers to Recovery algorithm.)
CarAssy A Horizontal Carriage Locked bit of 1 indicates the
picker fingers were fully retracted after a failure and
the translate pin is engaged. (For Byte 26, this attempt
refers to Retry algorithm and for Byte 30 it refers to
Recovery algorithm.)
B-16 Appendix B