HP 2600fx - Optical Disk Drive Command Reference Manual page 360

Table D-1 HP Surestore Optical Micro-Move ID Table
(For all models, EXCEPT 40fx, 80ex, 125ex and 220mx)
The following move IDs are only for 80fx, 160fx, 200fx, 160ex,
320ex, 400ex, 300mx, 600mx, and 700mx model jukeboxes.
Appendix D
Move ID Description
(hex.)
DA Move picker plunge assembly to a position where the
mailslot rotation actuator can be engaged to rotate the
mailslot out. Used when the state of the mailslot is
unknown and must be placed in a known state.
DB Retract the picker plunge assembly a short distance to
clear the thumbs away from the mailslot after rotating
the mailslot out.
DC Slow retract of the picker plunge assembly, pulling the
mailslot in. Checks that the cartridge is in properly. First
move of a rotate in.
DD Retract thumbs back into the picker after rotating the
mailslot out.
DE Plunge rotate mailslot 3 (not used).
DF Plunge rotate mailslot 4 (not used).
E0 Plunge rotate mailslot 5 (not used).
E1 First of two moves rotating the mailslot in. Quickly
retract the picker plunge assembly, pulling the mailslot
most of the way in. Followed by micro-move E3.
E2 Plunge out to rotate the mailslot almost all the way out.
E3 Short retraction of the picker plunge assembly until
pressure is felt. Used at end of rotating the mailslot in
and ensures that the mailslot has been rotated fully in.
E4 Short plunge out to relieve the pressure after rotating the
mailslot in.
E5 Short plunge out, feeling for pressure, to ensure that the
mailslot is rotated all the way out.
Micro/Macro-Moves
HP Surestore Optical Micro-Move IDs
D-15