HP 2600fx - Optical Disk Drive Command Reference Manual page 281

Table A-5
Code
(hex.)
44
45
46
47
48
4E
4F
50
51
52
54
57
70
71
72
73
7D
7E
7F
Drive Error Codes
Internal Error Codes
ODC Error Codes
Description
Cannot proceed with error correction because the syndrome
buffer was filled
Cannot correct the error bytes within the time of one sector
A write data transfer to the encoder was too short
A write data transfer to the encoder was too long
Unexpected sequence of the error correction occurred
Unexpected interrupt was detected in the ODC chip
Unexpected firmware sequence occurred in the ODC chip
Asynchronous interrupt of the DSP was detected
Unexpected ID value was detected
Both unexpected and expected ID value detected on one
track
Target sector was passed before the current position was
detected
A detected ID sector number was greater than the
maximum sector number
A Parameter List was not prepared
A sector number of the Parameter List was greater than the
maximum sector number
A sector count of the Parameter List is set to 0 in the W/R/S
Undefined condition is set in the DTS, DLS command
Setup command was issued while executing the Identify
operation
A command was issued while executing another command
Undefined command was issued
A-18 Appendix A