Read-Write Error Recover Page; Table 2-51 Read-Write Error Recovery Page 01H - HP 2600fx - Optical Disk Drive Command Reference Manual

Read-Write Error Recover Page

Table 2-51 Read-Write Error Recovery Page 01H
PS
AWRE
TB
Chapter 2
Byte 7 6
0 PS (1) Rsvd
(0)
1
2 AWRE Rsvd
(0)
3
4-7
8
9-11
The Parameters Savable bit of 1 indicates this
parameter page is savable in non-volatile RAM.
An Automatic Write Reallocation Enable bit of 1
enables the automatic reallocation of defective sectors
during the write operation of the Write commands
(0AH, 2AH, AAH), Write and Verify commands (2EH,
AEH), and WRITE LONG command (3FH).
For rewritable disks, automatic reallocation of defective
sectors occurs during these additional erase operations:
Erase 2CH and Erase ACH.
An AWRE bit of 0 does not enable automatic
reallocation of defective sectors.
A Transfer Block bit of 1 indicates that a data block that
is not recovered within the recovery limits specified is
transferred to the initiator before CHECK CONDITION
status is returned.
A TB bit of 0 indicates that such a data block is not
transferred to the initiator.
Mode Sense (Group 0) Command (1AH)
5 4 3
Page Code (01H)
Page Length (0AH)
TB RC Rsvd
(0)
Read Retry Count
Reserved (0)
Write Retry Count
Reserved (0)
SCSI-2 Drive Command Set
2 1 0
PER DTE DCR
2-57