HP 2600fx - Optical Disk Drive Command Reference Manual page 314

Table B-8 Hardware Error Codes (For the 40fx, 80ex, 125ex, and 220mx
models ONLY)
Error Code
(hex.)
B9H
BAH
BBH
SOLENOID ERROR CODES
BCH
BDH
BEH
BFH
FRU DETECTION TEST ERROR CODES
C8H
C9H
CAH
CBH
CCH
CDH
CEH
MISCELLANEOUS ERROR CODES
D0H
D1H
FCH
FDH
Appendix B
Failure Description
Drive #2 access error
Drive #3 access error
Drive #4 access error
Drive #1 access failure; possible solenoid failure
Drive #2 access failure; possible solenoid failure
Drive #3 access failure; possible solenoid failure
Drive #4 access failure; possible solenoid failure
Unable to gain proper servo control of the motors
Unable to move the Picker motor
Unable to move the Carriage motor
Unable to move either motor
Unable to find a hard stop while turning the Picker
motor
Unable to find a hard stop while turning the Carriage
motor
Excessive force required to move the Carriage leadscrew
Find magazine edge failed
Unexpected mailslot empty
The test can only be run from the Front Panel
The test can only be run from the SCSI interface
Autochanger Error Codes
Hardware Error Codes
B-27