HP 2600fx - Optical Disk Drive Command Reference Manual page 273

Table A-3
Error
Code
(hex.)
0134XXXX
0139XXXX
013AXXXX
013BXXXX
013CXXXX
0204XXXX
020AXXXX
020BXXXX
020CXXXX
020DXXXX
0210XXXX
0211XXXX
0212XXXX
0213XXXX
0250XXXX
0254XXXX
0255XXXX
026CXXXX
02B3XXXX
0321XXXX
0322XXXX
0323XXXX
Drive Error Codes
Internal Error Codes
Internal Error Codes
Message
The period of the synchronous data transfer is too short
The Clear Queue message was received
Initiator does not respond to reselection
Unusual SCSI controller condition
Unusual SCSI controller condition
An invalid microcode data was received
An invalid operation code was specified
An invalid LBA range was specified
An invalid field in CDB was specified
An invalid parameter list was specified
Parameter list length is wrong
The parameter saving function is not supported
The parameter is not currently saved
Cartridge eject was prevented
Attempt to write data to a written sector of a write-once disk
A queued command is cleared by another initiator
A command was received for the same ITL (or ITLQ) nexus
An invalid command for the write-once disk was specified
Invalid command when using 14x 512 b/s or 1024 b/s disk
Loader task ended with an unusual condition
Sensor failure during loader initialization
Failed recovery procedure during loader initialization
A-10 Appendix A