HP 2600fx - Optical Disk Drive Command Reference Manual page 312

Table B-8 Hardware Error Codes (For the 40fx, 80ex, 125ex, and 220mx
models ONLY)
Error Code
(hex.)
4BH
4CH
4DH
4EH
4FH
50H
51H
52H
53H
54H
EXERCISER TEST ERROR CODES
55H
56H
57H
59H
5AH
5BH
5CH
CALIBRATION SENSOR SYSTEM ERRORS
Appendix B
Failure Description
No sensor found (V4.2 code only)
Failed flip motion during the Find Home sequence (V4.5
code)
Motion error while checking for cartridge in the Picker
Unable to measure height of sensor on left side
Unable to measure height of sensor on right side
Excessive tilt of the Carriage/Picker assembly (away
from the drives)
Excessive tilt of the Carriage/Picker assembly (toward
the drives)
Excessive cone angle on Picker
Excessive stack tilt
Unable to complete an interrupted move at power up
Unable to find top of unit
Need to issue Initialize Element Status Command
Invalid test configuration
Exerciser unrecovered error
Invalid test configuration (elements reserved)
Initialize Element Status command failed
Shipping Diagnostic run with cartridges in the
mechanism
Autochanger Error Codes
Hardware Error Codes
B-25