HP 2600fx - Optical Disk Drive Command Reference Manual page 310

Table B-8 Hardware Error Codes (For the 40fx, 80ex, 125ex, and 220mx
models ONLY)
Error Code
(hex.)
19
1A
1B
1C
1D
1E
1F
20
MULTIFUNCTION PERIPHERAL IC ERROR CODES
29
2A
2B
MOTOR CONTROL IC ERROR CODES
2C
2D
2E
POWER SUPPLY ERROR CODES
33
34
DRIVE CONNECT ERROR CODES
38
Appendix B
Failure Description
SCSI connector loopback error in DB1 or C/D
SCSI connector loopback error in DB2 or MSG
SCSI connector loopback error in DB3 or REQ
SCSI connector loopback error in DB4 or ACK
SCSI connector loopback error in DB5 or ATN
SCSI connector loopback error in DB6 or SEL
SCSI connector loopback error in DB7 or BSY
SCSI connector loopback error in DBP or RST
RS-232 loopback data did not match what was sent (not
supported)
Timed out waiting for RS-232 loopback data (not
supported)
Timer A did not count down as expected (not supported)
Failed read\write test to Motor control IC
Motor control IC loopback test failed
Motor control IC RAM test failed
Low voltage power supply failed
High voltage power supply failed
Drive 1 not connected
Autochanger Error Codes
Hardware Error Codes
B-23