Multi-Function Transmitter; Voice Announcements; Screen Saver Option - Visonic PowerMaxComplete User Manual

Multi-Function Transmitter

Your system responds to signals sent by a 4-button,
MCT- 234 miniature 'keyfob' transmitter that you and
other users can carry (see figure 4). Your installer
can program the AUX (auxiliary) buttons to perform
various tasks, as required.
AWAY
HOME
MCT-234
Figure 4. Keyfob Transmitters
Pressing AWAY and HOME together for 2 sec.
initiates PANIC alarm. Pressing AWAY twice within 2
seconds initiates Latchkey arming.
A. Controlling a gate or another electrical
device: Pressing the AUX button opens/closes
an electrically-controlled gate, or controls a
chosen electrical device.
B. Arming the system in the INSTANT mode
(without an entry delay): Pressing the AUX
button immediately after arming, during exit
delay, causes the system to be armed without
an entry delay. This means that entering the
protected premises via any zone will trigger an
immediate alarm. You and other holders of
keyfob transmitters will have no problem,
because you can disarm the system before
entering by pressing the DISARM (
your transmitter before entry.
C. Getting status information: Upon pressing the
AUX button on your transmitter, the voice
module announces the system status over the
loudspeaker - not
PowerMaxComplete that does not have VOICE
option.
D-300886
Disarming by a keyfob whose battery voltage is
low
If you try to disarm the system with a keyfob whose
battery voltage is low, a protest beep will be heard for
15 seconds (if this beep is enabled by the installer).
During this period you should press again the disarm
button of the keyfob or control panel (for the control
DISARM
panel, user code is required) to disarm the system. If
you perform this action during the 15 seconds period,
the Low Bat message will be stored in the event log.
AUX
If the disarm button is not pressed again during the
15 seconds period, perform either of the following
actions:
A. Press AWAY twice to arm the system, otherwise
B. Press AWAY and then press disarm button, to

Voice Announcements

(Not applicable in PowerMaxComplete that does not
have VOICE option).
The pre-recorded voice announcements respond to
your commands by announcing what the system is
doing and by prompting you to perform certain
actions. They also announce alarms, troubles and
identify the source of each event.
) button on

Screen Saver Option

The Screen Saver option (if enabled by the installer)
applicable in
causes that when no key is pressed during more
than 30 seconds, the display is "PowerMax" and the
LEDs do not light (to prevent an intruder to know the
system status). The normal display returns after
pressing the
code (Refresh by Code) or after pressing any key
(Refresh by Key), as selected by the installer.
If Refresh by Key was selected, the first pressing of
any key (except Fire and Emergency) causes normal
display return and the second press performs the key
function. Regarding the Fire and Emergency keys,
the first key press causes normal display return and
also performs the Fire/Emergency function.
INTRODUCTION
the system will not be
acknowledgement (from the user that he knows
about the Low Bat) will not be stored in the event
log.
acknowledge, otherwise the acknowledgement
will not be stored in the event log.
button followed by entering user
armed and an
7