Table of Contents
Advertisement
4.9 User Interface Customization
4.9.1 Enabling Trouble Beeps
Under trouble conditions, the sounder emits a series of 3 short beeps once per minute. Here you determine whether this
special beeping sequence will be active, inactive, or just inactive at night (the range of "night" hours is defined in the factory
but is usually from 8 PM until 7 AM).
The 3 options are: enable beeps (default in USA), off at night (default) and disable beeps.
To Enable Trouble Beeps
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
BEEPS].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [11:TROUBLE BEEPS].
You can now press the
"
" or press the
DEFINE PANEL
4.9.2 Enabling Piezo Beeps
Here you determine whether warning beeps will sound or muted during exit and entry delays. An additional option is to
mute the warning beeps only when the system is armed "HOME".
Options: enable beeps (default), off when home (default in UPGM and disable beeps.
Note: When exit beeps are disabled toward the end of a delay, the happy (success) melody will sound.
To Enable Piezo Beeps
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Click the
or
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
D-302756
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [11:TROUBLE
or
button to take you to "
button repeatedly and select the [DEFINE PANEL]
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
button
.
I
OK
I
OK
".
button
.
I
OK
I
OK
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
11:TROUBLE BEEPS
I
OK
SELECT OPTION
I
OK
11:TROUBLE BEEPS
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
49
Advertisement
Table of Contents
