Table of Contents
Advertisement
4.8.3 Configuring Exit Delay Duration
An exit delay allows the user to arm the system and leave the protected site via specific routes and doors without causing
an alarm. Slow-rate warning beeps start sounding once the arming command has been given, until the last 10 seconds of
the delay, during which the beeping rate increases. Location No. 3 allows programming of the exit delay length. Available
options are: 30s, 60s (default), 90s, 120s, 3m, and 4m.
Note: To comply with CP-01 requirements, "30s" option is not available.
Note: To comply with UL requirements, the exit delay must not exceed 120 sec.
To Configure the Exit Delay Duration
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
Press
and make the selection and then press
7.
I
OK
The PowerMax10-G2 display will revert to [03:BELL/REP.OPT].
You can now press the
"
" or press the
DEFINE PANEL
4.8.4 Enabling Quick Arm
Here you determine whether the user will be allowed to perform quick arming or not. Once quick arming is permitted, the
control panel does not request a user code before it arms the system.
The two options are: quick arm ON (default in USA) and quick arm OFF (default).
To Enable Quick Arm
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
46
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [03:EXIT DELAY].
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
button
.
I
OK
I
OK
".
button
.
I
OK
I
OK
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
03:EXIT DELAY
I
OK
SELECT OPTION
I
OK
30:BELL/REP.OPT
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
D-302756
Advertisement
Table of Contents
