Ending The Multipoint Connection - Sony PCS-XG80 Operating Instructions Manual

Ending the Multipoint Connection

1
Press the CONNECT (
The following menu appears:
Disconnect A
Disconnect D
Disconnect E
The alphabetic letters A to E (or A to C) indicate the connected sequence
of terminals.
The terminal names are displayed in the menu if you set "Display Terminal
Name" to "Show temporarily" or "Always show" on the Menu Screens
page in the General setup menu.
2
Use the V, v, B or b button on the Remote Commander to select the
terminal to be disconnected, then press the ENTER button.
Disconnect A: Disconnects the terminal connected first.
Disconnect B: Disconnects the terminal connected second.
Disconnect C: Disconnects the terminal connected third.
Disconnect D: Disconnects the terminal connected fourth.
Disconnect E: Disconnects the terminal connected fifth.
Disconnect All: Disconnects all the terminals.
The selected terminal is disconnected.
You can also disconnect all the terminals by pressing the DISCONNECT
( ) button on the Remote Commander.
To cancel the disconnection
Select "Cancel" in step 2, then press the ENTER button on the Remote
Commander.
) button on the Remote Commander.
Disconnect B
Disconnect All
Cancel
Disconnect C
Ending the Multipoint Connection
203