Switches the monitored picture between the remote and local sites." at the
bottom of the monitor.
Each press of the F1 button on the Remote Commander swaps the location of
To switch the display to the received RGB picture
When you receive an RGB computer picture from a remote party during
communication, the instruction "F2: Switches to the RGB monitor screen." is
displayed at the bottom of the monitor. The RGB picture is displayed by
pressing the F2 button on the Remote Commander.
To restore the previously displayed picture, press the F2 button again.
Switching the Video Output Equipment
While in communication, you can change the monitor or video equipment to
which the picture of the system is output.
Press the LAYOUT button on the Remote Commander.
The Layout menu appears.
Use the V, v, B or b button on the Remote Commander to select the
monitor select mode, then press the ENTER button.
HDMI: Outputs the picture to external equipment connected to the HDMI
RGB: Outputs the picture to external equipment connected to the RGB
HDMI+RGB: Outputs the picture to both equipment connected to the
HDMI OUT and RGB OUT connectors.
The picture outputs to the selected equipment.
To store the selected monitor mode in the memory of the system, use the
V, v, B or b button on the Remote Commander to select "Save", then press
the ENTER button.
The Layout menu disappears.
If "Monitor Select Mode" is set to "HDMI+RGB" when no HDMI monitor is connected
to the Communication System, you cannot view the menus. Before making this setting,
be sure to connect an HDMI monitor.
Switching the Picture Displayed on the Monitor Screen