Download  Print this page

Sony PCS-XG80 Operating Instructions Manual Page 38

Hd visual communication system.
Hide thumbs

Advertisement

Setup
For details, see "RF Remote Control Reception" on the Device Setup page
of the General setup menu on page 81.
For the procedure on how to operate the menus, see "Opening the Setup
Menu" on page 60.
3
Within three minutes after the power of the Communication System is
turned on, locate the Remote Commander closer to the RF receiver at the
rear of the Camera Unit, and press the RETURN and TOOLS buttons at the
same time.
The Remote Commander and the Camera Unit enter pairing mode, and the
LED indicator on the Remote Commander flashes rapidly.
4
Press the ENTER button on the Remote Commander.
If the LED indicator on the Remote Commander flashes more slowly,
pairing the units has succeeded.
The pairing between the Communication System and the Remote
Commander is disabled.
When pairing has failed
The LED indicator on the Remote Commander continues flashing rapidly. In
this case, press the ENTER button on the Remote Commander again.
To cancel pairing
Press the
Notes
• When the LED indicator does not flash even if you press any button on the Remote
Commander, the batteries might be exhausted. Replace both batteries with new ones.
• Once pairing is established between the units, it will not be erased even if the batteries
are replaced.
• Operable distance is 10 m (32.8 ft.). Depending on the circumstances, a longer
operable distance may be possible.
38
Preparing the System
General
Device Setup
General1
Terminal Name
Standby Mode
Standby Time
Last Number Registration
Control by Far End
Language
System LED Brightness
Camera LED Brightness
RF Remote Control Reception
?
/
1
(power) switch on the Communication System.
On
15minutes
Off
On
English
Dark
Dark
Camera
Save
Cancel

Advertisement

Table of Contents

   Related Manuals for Sony PCS-XG80

This manual is also suitable for:

Pcs-xg80gPcs-xg80sPcs-rf1

Comments to this Manuals

Symbols: 0
Latest comments:
  • suriya Dec 10, 2013 06:56:
    how to use the symbols in dialing pad....?
    h​elp me