Lan Setup Menu - Sony PCS-XG80 Operating Instructions Manual

"Input Select (AUX)" on the Basic Setup1
page of Audio setup menu cannot be selected.
Video Input
Allows you to select the video input.
Camera: Selects the camera picture from
the camera connected to the CAMERA
connector.
S-VIDEO: Selects the picture from the
external equipment connected to the S
VIDEO IN connector.
RGB: Selects the picture from the external
equipment connected to the RGB IN
connector.
YPbPr: Selects the picture from the external
equipment connected to the YPbPr
jacks.
Audio Input
Allows you to select the audio input which is
linked to the video input selected in "Video
Input" when "Link to Audio Input" is set to
"On".
MIC: Inputs audio from the microphone.
AUX: Inputs audio from the external
equipment.
MIC+AUX: Inputs audio both from the
microphone and external equipment.
Input Select (MIC)
Input Select (AUX)
Allows you to select the audio input from the
microphone and/or external equipment
when "Link to Audio Input" is set to "On".
The options that can be selected vary with
the Audio Input setting.
When you select "MIC" from "Audio
Input", you can select one of the following
four options. When you select "AUX", you
can select "AUDIO 1" or "AUDIO 2".
When you select "MIC+AUX", you can
select two options: one microphone input
from "MIC (A1/A3)", "EC MIC (A7)",
"AUDIO 1" or "AUDIO 2", and one
auxiliary external input from "AUDIO 1" or
"AUDIO 2".
MIC (A1/A3): Select use of the PCS-A1
microphone (supplied with the PCS-
XG80) or PCSA-A3 microphone (not
supplied) connected to the MIC (A1/A3)
jacks on the Communication System.
EC-MIC (A7): Select use of the PCSA-A7
echo canceling microphone (not
supplied) connected to the EC-MIC
(A7) jacks on the Communication
System.
AUDIO 1: Select to input the audio of
external equipment connected to the
AUDIO 1 IN jacks on the
Communication System.
AUDIO 2: Select to input the audio of
external equipment connected to the
AUDIO 2 IN jacks on the
Communication System.

LAN Setup Menu

The LAN setup menu is used to set up LAN
connection.
For details about the settings, consult your
network administrator.
Note
The contents of the LAN setup menu vary with
the "Use LAN2" setting in the Line Interface
setup menu, or "Internet Protocol" setting in
the Administrator setup menu.
The LAN page number after the LAN2 page
also varies according to the number of setting
items.
LAN
Basic Setup
Host Name
Enter your host name (up to 30 characters).
DHCP Mode
Allows you to select whether the Dynamic
Host Configuration Protocol (DHCP) server
is enabled.
Auto: The IP address, network mask,
gateway address and DNS address are
automatically assigned.
Off: Disables the DHCP server. In this case,
enter an IP address, network mask,
gateway address and DNS address.
IP Address
Enter the IP address.
Network Mask
Enter the network mask.
Registering Local Information
73