Download  Print this page

Programming The Remote Commander To Operate The Camera Unit - Sony PCS-XG80 Operating Instructions Manual

Hd visual communication system.
Hide thumbs

Advertisement

• If battery leakage occurs, clean the battery compartment and replace all the
batteries with new ones.

Programming the Remote Commander to Operate the Camera Unit

The supplied Remote Commander controls the HD Visual Communication
System using the radio frequency of 2.4 GHz. The Remote Commander and
the Communication System are paired to prevent interference from other
Remote Commanders and Systems.
Pairing between the Remote Commander and the Communication System is
programmed at the factory. If the Communication System is installed in
shielded locations, such as under a desk or in a rack, it may not be controlled
by the Remote Commander, depending on the conditions of radio-wave
reception. In this case, pair the PCSA-CXG80 HD Camera Unit with the
Remote Commander.
Note
When performing pairing procedure, be sure to turn off other HD Visual
Communication Systems or HD Camera Units located nearby that are not targets for
pairing. If multiple devices are turned on, the Remote Commander might pair device
other than the target one.
To pair the Camera Unit with the Remote Commander
1
Press the
The
/
?
1
indicator lights in green when the Communication System turns on.
2
Set "RF Remote Control Reception" to "Camera" in the General setup
menu.
POWER/STANDBY
LED indicator
PRESENTATION
/
/
F1
F2
F3
F4
4
LAYOUT
VIDEO INPUT CAMERA
VOLUME
ZOOM
T
ENTER
3
W
RETURN
TOOLS
BACK
SPACE DISCONNECT
CONNECT
1
2
3
ABC
DEF
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
TONE
DOT
0
ON/OFF
MIC
?
/
1
(power) switch on the Communication System to turn it on.
(power) indicator on the Communication System flashes. The
?
1
/
(power) indicator
/
1
Preparing the System
OPEN
37

Advertisement

Table of Contents

   Related Manuals for Sony PCS-XG80

This manual is also suitable for:

Pcs-xg80gPcs-xg80sPcs-rf1

Comments to this Manuals

Symbols: 0
Latest comments:
  • suriya Dec 10, 2013 06:56:
    how to use the symbols in dialing pad....?
    h​elp me