Ending The Multipoint Connection - Sony IPELA PCS-XG100 Operating Instructions Manual

Ending the Multipoint Connection

1
Press the DISCONNECT (
The following menu appears:
Disconnect A
Disconnect D
Disconnect G
The alphabetic letters A to H (or A to C, A to E) indicate the connected
sequence of terminals.
The terminal names are displayed in the menu if you set "Display Terminal
Name" to "Show temporarily" or "Always show" on the Menu Screens
page in the General setup menu.
2
Use the V, v, B or b button on the Remote Commander to select the
terminal to be disconnected, then press the ENTER button.
Disconnect A: Disconnects the terminal connected first.
Disconnect B: Disconnects the terminal connected second.
Disconnect C: Disconnects the terminal connected third.
Disconnect D: Disconnects the terminal connected fourth.
Disconnect E: Disconnects the terminal connected fifth.
Disconnect F: Disconnects the terminal connected sixth.
Disconnect G: Disconnects the terminal connected seventh.
Disconnect H: Disconnects the terminal connected eighth.
Disconnect All: Disconnects all the terminals.
The selected terminal is disconnected.
You can also disconnect all the terminals by pressing the DISCONNECT
( ) button on the Remote Commander.
To cancel the disconnection
Select "Cancel" in step 2, then press the ENTER button on the Remote
Commander.
Disconnect B
Disconnect E
Disconnect H
Cancel
) button on the Remote Commander.
Disconnect C
Disconnect F
Disconnect All
Ending the Multipoint Connection
215