Download  Print this page

Sony PCS-XG80 Operating Instructions Manual Page 232

Hd visual communication system.
Hide thumbs

Advertisement

Symptom
No connection.
232
Troubleshooting
Cause
If you disconnect the
communication with an abnormal
procedure, e.g., unplugging an
ISDN cable or turning off the
system during communication, you
may not connect to the ISDN line
for a while (when using ISDN).
If you repeat plugging/unplugging
or turning on/off, you may not
connect to the network for a while
(when using LAN).
LAN connection timeout (when
using LAN).
Packet for communication is not
acceptable under the current LAN
environment (when using LAN).
The remote terminal is not turned
on.
It takes a long time for the remote
party to be able to answer from the
standby mode.
The remote party is in
communication with another party.
Answering the call is not permitted
by the remote terminal as it is
operating for setups, etc.
The remote terminal is not set to
auto answer mode.
The ISDN telephone numbers are
not set up in the remote terminal
(when using bonding).
The eighth digit and up of the ISDN
telephone numbers are not the same
when connecting using bonding
(when the remote party uses the
communication system of an older
model such as the PCS-1600).
There is some problem with the
remote terminal.
A message appears on the screen.
Solution
Turn off the power of the system and
wait for a few minutes before turning
it on again.
Turn off the power of the system and
wait for a few minutes before turning
it on again.
Try again later.
Consult with the system administrator
so that the packet for Communication
becomes acceptable under your LAN
environment.
Ask the remote party to turn on the
terminal.
Ask the remote party to cancel the
standby mode.
Call the remote party after they end
the communication with another
party.
Ask the remote party to permit
answering a call.
Ask the remote party to set the
terminal to auto answer mode, or to
answer a call manually.
Ask the remote party to set up "Area
Code" and "Local Number" in the
ISDN Setup menu correctly (page
78).
Connect without using bonding, or
use the ISDN telephone numbers that
are the same in the eighth digit and
up.
Try to dial the number of another
terminal.
See "On-Screen Messages" (page
228).

Advertisement

Table of Contents

   Related Manuals for Sony PCS-XG80

This manual is also suitable for:

Pcs-xg80gPcs-xg80sPcs-rf1

Comments to this Manuals

Symbols: 0
Latest comments:
  • suriya Dec 10, 2013 06:56:
    how to use the symbols in dialing pad....?
    h​elp me