This section describes the typical system connections.
• Be sure to turn off all the equipment before making any connections.
• Do not connect/disconnect the camera cable, interface cable, or pen tablet with the power
on. Doing so may damage the Camera Unit, Communication System or ISDN Unit.
• For safety, do not connect the 100BASE-TX/10BASE-T connector to a network that
applies excess voltage via the 100BASE-TX/10BASE-T connector.
• Used with the Camera Unit or ISDN Unit for the first time, the Communication
System may automatically upgrade the software of the connected equipment.
Upgrade the software according to the message displayed on the monitor screen. Be
sure not to turn off the Communication System or disconnect the cable during
upgrading. Otherwise, it may cause a malfunction of the system.