Adjust the angle so that the desired angle of view is obtained with the V,
v, B or b button on the Remote Commander.
The selected camera pans and tilts, then the adjusted picture will be
displayed in the small window or in full screen.
Use the ZOOM button on the Remote Commander to zoom in or out.
Press the T (Telephoto) button to zoom in and the W (Wide angle) button
to zoom out.
For details on digital zoom, see "To use the digital zoom function" on page
To control the remote camera
• To control the remote camera, set "Far End Camera Control" (page 68) to
"On" in the Communication setup menu for both the local and remote sites.
If this setting is not configured properly, you will not be able to control the
• You cannot control the remote camera during a session if the remote control
format of the remote camera is not H.281. If you cannot control the remote
camera, ask the remote party about the remote control format of his camera.
• If the local and remote parties try to control the same camera at the same
time, the camera may not operate correctly.
Adjusting the Brightness
Normally, the brightness is automatically adjusted to obtain optimum levels.
You can also adjust it manually.
It is recommended that the brightness be adjusted automatically to obtain
To adjust the brightness manually
Press the CAMERA button on the Remote Commander, or press the V, v,
B or b button to select "Camera" in the Home menu and press the ENTER
Adjustments > Angle Adjustment
Local Camera : First Camera
Adjusting the Camera