Default Setup - Intermec ESim v4.20 Programmer's Reference Manual

Chapter 3—Setting Up the Printer

Default Setup

Parameter
Error/Status Char.
Density
Character Set
Top of Form backup JF
Media feed adjust
Label Gap Sensor
Char. substitution
Form Length
Label Width
Reference Point
Print Speed
Reply Character
Error Handling
Windows Mode
Serial Port
Print Direction
Printhead Resolution Measures
203.2 dpi printheads
300 dpi printheads
Th e setup will be reset to default values if...
• the printer's fi rmware is upgraded using a fi rmware cartridge,
• or the Feed key is pressed more than 3 seconds in the Dump Mode.
14 Intermec EasyCoder ESim v4.20—Programmer's Reference Manual
Command Default Setting
eR0,0 XOFF/XON-handling
10
D10
I8,0,001 8 bits, code page 0, country code 001
Enabled
j136 136 dots (at 203.2 dpi)
204 dots (at 300 dpi)
j204
ON LTS disabled, TT mode, reverse gap disabled.
cutter disabled
oR No substitution
Continuous mode, print gap 24 dots
Q24,0
q832 832 dots (at 203.2 dpi)
1208 dots (at 300 dpi)
q1208
R000,000 X:000;Y000
50 mm/sec. (2 inches/sec.)
S2
UC0 None
Error reporting disabled
UN
WN Disabled
9600 baud, no parity, 8 data bits, 1 stop bit
Y96,N,8,1
ZT Start printing at top of image buff er
203.2 dpi (8 dots/mm) in both directions
300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path