Legal Information; General Legal Information; Disclaimer; Trademarks - SINTERIT LISA X Original User Manual

Sls 3d printer

18. LEGAL INFORMATION

Where this manual refers to Sinterit or the Company or "us/our", this means Sinterit sp. z o.o. with its legal seat in Krakow,

registered by the District Court for Kraków-Śródmieście in Krakow, XI Commercial Division of the National Court Register

under number: 535095, NIP (tax number): 6793106416.

This document contains material protected under copyright and industrial property laws. In particular, this means that the

document may not be reproduced or modified without the consent of Sinterit.

This manual serves to assist you in the correct use of the device, perform basic maintenance, and, if necessary, solve

simple problems, allowing you to maintain the device in good condition.

This manual contains content exclusively for the provision of information and for use by individuals who have been

professionally trained in the operation and maintenance of the equipment described below.

The information contained in this document is intended for use only with the product made by Sinterit and called Sinterit

Lisa X SLS 3D Printer.

Due to the constant development of Sinterit products the information contained in this manual as well as any specifications

and markings issued or placed on Sinterit products by the Company are subject to change without notice.

Sinterit is not responsible for any use of this information about other products.

Although every effort has been taken to provide accurate information about the product, Sinterit disclaims, to the widest

extent permitted under the applicable law, any and all liability for any incorrect information or omission, and for anything

that may result from such errors or omissions. Sinterit reserves the right to correct any and all errors and omissions at any

time.

Further limitations or exclusions of Sinterit liability may result from the applicable laws or agreements entered into with

the buyer of the products.

The Sinterit logo is a registered trademark of the Company.

Sinterit Lisa X SLS 3D Printer Original User Manual | 83

Table of Contents

Do you have a question about the LISA X and is the answer not in the manual?