Spare Parts For Lisa X - SINTERIT LISA X Original User Manual

Fig. 13.102 Clean the reflector thoroughly
before applying the new sealing.
16. Lift the heating module (fig. 13.104).
17. Secure the heating module with the captive screw/split
pin (fig. 13.104).
18. Good job. The printer is ready to work again.

13.15 Spare parts for Lisa X

List of spare parts:
• Pyrometer module
• Laser protective glass
• Recoater strip or short cord*
• Print Bed sealing
• Feed Bed sealing
• Reflector sealing*
*Marked elements may be different or not installed, depending on printer revision.
• Supply kit – the basic set of spare parts supplied with the printer. Includes Recoater strips/cords and infrared bulbs.
• Consumables kit – Extended spare parts kit, extra charge.
IMPORTANT!
Sinterit reserves the right to alter availability of spare parts without prior notice. Please contact our
After Sales department for assistance, if you think you require a replacement item not listed above
or in the current offer.
%
• F-Theta scanning lens
• Recoater drive cord*
• Recoater drive belt (GT2)
• Infrared bulbs
Fig. 13.103 Apply the new reflector sealing.
Fig. 13.104 Reinstall the heating module.
Sinterit Lisa X SLS 3D Printer Original User Manual | 72
NEW
SEALING