Preparing The Print Chamber - SINTERIT LISA X Original User Manual

3. Make sure the print chamber is free of any unwanted items that may interfere with moving the Recoater.
4. Press POSITION BEDS to begin the positioning process of the Beds (fig. 6.5).
5. Once the positioning process is finished, fill the Feed Bed up with the desired powder. You may use the powder funnel
provided in the Dedicated Powder Tools (fig. 6.6). Press DONE.
PRINTING - POSITIONING
Fig. 6.5 POSITION BEDS screen.
IMPORTANT!
• Add a little more powder than fits in the Feed Bed.
• The information which powder to use has been displayed on the printer screen as well as in the
Sinterit Studio software end report.
6. Compress the powder using the powder trowel provided
in the Dedicated Powder Tools. This will release any
residual air accumulated in the Feed Bed. Press DONE.

6.5 Preparing the print chamber

ATTENTION!
Risk of crushing hands!
• The moving Recoater can cause hand injuries.
• Be careful not to crush your hands when closing the printer lid.
Fig. 6.4 Lifting the printer lid.
Position Beds for printing.
Make sure that the path of Recoater is not
obstructed
POSITION BEDS
Fig. 6.6 Filling the print chamber with powder using the funnel.
Fig. 6.7 Compressing the powder using the powder trowel.
Sinterit Lisa X SLS 3D Printer Original User Manual | 28