Replacing The Print Bed Sealing - SINTERIT LISA X Original User Manual

32. Mount the cord using screws on the opposite side (fig.
13.24).
33. Tighten all the screws from both sides. If access to the
screws is problematic, use the steering arrows to move
the Recoater in the right direction.
34. After mounting the cord use steering arrows to move
the Recoater.
35. Check if the roller is rolling properly. Correct installed
cord is moving slightly right and left on the bearing
system.
36. Reinstall the black Recoater cover (fig. 13.25).
37. Tighten the screws securing the black Recoater cover.
38. Good job. The maintenance timer will reset to zero.

13.5 Replacing the Print bed sealing

You will need: 2.5 [mm] allen key, ATEX/Intertek vacuum cleaner, compressed air, metal spatula, plastic spatula, scissors,
new fibreglass rope.
1. On the PRINTER STATUS tab, select the PRINT BED SEALING position.
2. The Print Bed sealing maintenance tab will appear on the screen. You can use the step-by-step guide (press FOLLOW
GUIDE) or perform the replacement yourself.
3. In this case, mark MAINTENANCE DONE once you have completed the procedure, and then the DONE button. The
timer will reset to zero (fig. 13.26).
ATTENTION!
Always wear appropriate personal protective equipment when working with
powder: clothing, goggles, mask, and gloves. You will find a suitable kit in
the Dedicated Powder Tools package.
Fig. 13.26 The screen of the maintenance of the Print Bed sealing.
Fig. 13.24 Installing a new Recoater cord.
Fig. 13.25 Reinstall the black Recoater cover
and tighten the screws.
Sinterit Lisa X SLS 3D Printer Original User Manual | 52