SINTERIT LISA X Original User Manual page 22

3. Make sure that the E-STOP button is released. If not,
twist it clockwise up to the stop and release (fig. 5.2).
4. After a few seconds, a short tutorial will appear on the screen. The following steps will be explained in detail later in
the tutorial.
5. Adjust the position of the screen to yourself. Pull the strap and change the orientation of the screen.
6. Connect the source of inert gas to the inlet nipple on the back of the printer. After connecting, toggle the button on
the screen.This step is optional.
7. Choose UNLOCK LID on the printer screen (top-right corner).
8. Push on the lid and pull it up using the lid handle (fig. 5.3).
IMPORTANT!
After 10 seconds the electrolock will reactivate and it will no longer be possible to lift the lid. If you
still want to open the printer, slide the UNLOCK LID button again on the printer screen.
9. Remove the Start up box with the laser protective glass and other accessories (fig. 5.4).
PRINTING
Fig. 5.3 Lifting the printer lid.
Fig. 5.4 Removing the box with accessories.
Fig. 5.2 Releasing the E-STOP button.
10 s
UNLOCK LID
ADD NEW PRITJOB
UNLOCK OVERFLOW
OPEN TH DOOR
Sinterit Lisa X SLS 3D Printer Original User Manual | 22