Removing And Cleaning The Printout - SINTERIT LISA X Original User Manual

8. REMOVING AND CLEANING THE PRINTOUT

ATTENTION!
Remember to regularly perform printer maintenance as instructed. Exceeding the designed lifetime
of printer components may negatively impact printouts quality and cause damage to the device.
IMPORTANT!
As a safety precaution, moving parts inside the printer are locked in place while the Printer door is
open.
1. Once the screen displays a message saying FINISHED
(fig. 8.1) the printing process is over. Choose the
REMOVE PRINTOUT button to retrieve it from the print
chamber.
2. After the print is finished, the screen may show a
message saying MAINTENANCE TIME. It contains
information on required maintenance to certain
components of the printer in the near future.
• For more information, see Chapter 13. Lisa X
maintenance.
If the message hasn't appeared, it means that no
components require any maintenance. Press GOT IT.
3. Press UNLOCK LID on the screen to release the electrolock and allow the printer to be opened. Remember, you only
have 10 seconds to open it before the lock activates again.
4. Push on the lid and pull it up using the handle (fig. 8.2).
Fig. 7.3 Screen during printing with the E-STOP button pushed in.
Fig. 8.2 Lifting the printer lid.
CAMERA VIEW
Fig. 8.1 The screen informs the user that the printing is finished.
Sinterit Lisa X SLS 3D Printer Original User Manual | 32
PRINTING
FINISHED (100%)
MODEL NAME PUMP_01
MATERIAL PA12
INERT GAS NO
REMAINING TIME 0h:0m
LAYER 1543/3455
PRINTER TEMPERATURE 150°C
REMOVE PRINTOUT