Scode Upload - SINTERIT LISA X Original User Manual

Response info
• PrintProgress – The progress of the whole print (float in the range of 0-1);
• EstimatedTimeLeftS – estimated print time (all including warmup and cool down);
• IsPrintInProgress – value true/false;
• LayerCount - number of printout layers;
• CurrentLayer – current layer;
• StatusMessage – statuses: „STARTING", „WARMING UP", „PRINTING", „COOLING DOWN", „READY", „Not printing";
• CurrentSCodeFilename – name of the currently printed file;
• IsPrintoutReadyToRemove – value true/false;
• PrintSurfaceTemperature – print temperature in degrees [°C];
• PrintInterruptionReason – in the case of a critical error, supplemented with an error;
• WarmupProgress – the progress for warmup (float in the range of 0-1);
• EstimatedWarmupTimeLeftS – estimated warm-up time left;
• PrintingStageProgress – the progress for just laser printing (float in the range of 0-1);
• EstimatedPrintingStageTimeLeftS – estimated time of the current printing phase;
• CooldownProgress – the progress for cooldown (float in the range of 0-1);
• EstimatedCooldownTimeLeftS – estimated cooldown time;
• Wifi_status – info about wifi (name, signal strength);
• Errors – table with errors (empty if there are no errors);
• Printer_serial_number – serial number of the machine;
• Software_version – current software version;
• Last_printout_start_time – last printout start time;
• Last_printout_finish_time – last printout finish time;
• Estimated_printout_finish_time – estimated printing finish time.

15.2 Scode upload

Upload single files with a FormData HTTP request.
POST <printer-ip>:2222/uploadFile
Use the IP address assigned to the printer (SETTINGS
formData key value example:
key value
scode yourScode.scode
Response information:
• success - value true/false (scode uploaded);
• response errors.
Potential response title error values:
• Only scode files are allowed – you are trying to send an improper file;
• Not enough free space, try to remove old scode first – not enough space on the printer internal disk.
IMPORTANT!
Send only files generated in Sinterit Studio.
SYSTEM INFO).
Sinterit Lisa X SLS 3D Printer Original User Manual | 78