Safety Requirements While Using The Lisa X Printer - SINTERIT LISA X Original User Manual

STOP!
Risk of electroshock!
• Never touch electric wires, switches, buttons, etc. with wet hands.
• Never pull the machine by means of the power cable.
• When connecting/disconnecting the plug to/from the power socket, always
hold the cover, not the cable.
• In the event of the cable being damaged, the machine must not be used.
• Never disassemble, modify or repair the power cable, plug, devices inside the
printer, except as described in the product manual.
• Do not place objects on the power cable.
• Do not place power cable in path where people will have to walk or run.
ATTENTION!
It is recommended to use UPS units that, in the case of a momentary power failure, will allow the
printing process to finalise.
ATTENTION!
Tle Lisa X printer must always be connected to a grounded outlet to prevent
electric shock in the event of a fault.

2.5 Safety requirements while using the Lisa X printer

WARNING!
• Before printing, always make sure the printer is free of all external materials such as debris,
oil, equipment and other objects that could affect the operation and cause injury to people.
• Before each use, check the device for damaged and/or defective parts.
• In the case of a defect or malfunction of the device, have it repaired by a qualified person/
company first.
• Make sure all the guards and protection devices are in place and that all the safety devices are
in place and working properly.
ATTENTION!
• During printing, if there is a lot of smoke, irritating smell or other alarming
circumstances take place, press the E-STOP button. It will immediately cut off
the power from the printer.
• However, remember that it is impossible to open the printer (e.g.: by lifting the
lid) until the temperature inside has dropped below 50 [°C] and the UNLOCK
LID option is available.
Sinterit Lisa X SLS 3D Printer Original User Manual | 10