Troubleshooting; Infographics And Messages - SINTERIT LISA X Original User Manual

16. TROUBLESHOOTING

16.1 Infographics and messages

The printer displays a status message on the home screen. It will inform you if the device is ready to be used, or if there
are actions to perform before it is.
Fig. 16.1 On the home screen, the infographics are visible on the left side, with the status message in the middle right.
BLUE colour
READY The printer is ready for printing (default status).
PHS mode active – The printer shows the flow dedicated to use with PHS.
The Security System active – The security system protects against potential hazards that may occur
during the operation of the printer. In the event of a threat, it disables all components that could pose
a risk.
Flash drive connected – There is a possibility to: select print jobs from it, select update files from it,
copy the logs from the printer to it, and send them to the Sinterit Support in case of problems.
Remote Support Service – Remote Support Service enables the Sinterit Support Team to remotely
access the printer.
YELLOW colour
HIGH The printer cannot currently be opened due to high temperature inside the chamber, wait for it to cool
TEMPERATURE down.
PRINTOUT
There is a finished printout in the chamber, ready to be removed.
INSIDE
CLEANING
The printer must be cleaned before it can be used again.
NEEDED
MAINTENANCE
There are outstanding maintenance items to complete, before you can print again.
NEEDED
Refers to Printer status / errors.
Refers to Printer status / errors.
The temperature is too high.
Sinterit Lisa X SLS 3D Printer Original User Manual | 79